How to Make Simple Solid Objects in AutoCAD

Primitive solid objects serve as the foundation of every AutoCAD 3D design. These may be made using AutoCAD commands, or you can make your 3D solids using alternative AutoCAD techniques. The following solids may be created using AutoCAD commands:

Box

Wedge

Cone

Sphere

Cylinder

Pyramid

Torus

These forms may be merged in many ways, using the numerous altered commands available in AutoCAD, to produce almost any shape. So, how can we put them to use? Let's get this party started!

To use these instructions to construct anything in 3D, you must first be in 3D mode. To construct the box command, type BOX and press ENTER, then pick the first corner, the other corner, and the height (just like drawing a rectangle in 2D but with height). If you want autocad training in delhi from industry experts then you should join Tgc India.

The process of creating a wedge is quite similar to the process of drawing a box (because it is a sliced box). We just enter WEDGE and press ENTER, then choose the first corner, the other corner, and the height. The direction of the slope is determined by where you start your first corner with this design; however, we may always ROTATE.

Aside from the box, the cone is perhaps the simplest 3D basic solid. For this object, we just write CONE and press ENTER, then choose a radius and height for the cone. Simple, isn't it?

By typing SPHERE and choosing a start point and radius, you may build a sphere. The sole disadvantage of the sphere is that one radius (half of the sphere) will be below and one radius will be above the plane you choose. Simply use the move command to resolve this.

Cylinders are ubiquitous in the world, and hence in our designs. To make one, just write CYLINDER, choose a start point and radius, and then specify a height. Tap here for the best autocad training in Delhi.

The pyramid is one of the more difficult 3D primitives to make. The most common method is to inscribe the sides of the pyramid's base inside a circle. This signifies that the points of your pyramid base are one diameter apart diagonally. Simply write PYRAMID to make a pyramid. Choose your starting position, the radius of the circle you want to inscribe in, and height.

The torus is the last form on this list. This geometry has the potential to transform into a variety of other forms. To make a torus, enter the TORUS command and then provide the start point, radius of the torus, and radius of the outer "doughnut."

These shapes will assist you in getting started with AutoCAD 3D drawing. Check out the links below for a video of this instruction as well as a site with additional tutorials.